CGS PCB mounting rail
CGS91 the CGS pcb mounting rail for Serge style panels.
|O1 to O10||Outputs|
|0V||0V/GND power rail|
|+VE||positive voltage power rail.|
|+V2||unspecified voltage power rail. Use for 6V, 5V, etc.|
|-VE||negative voltage power rail.|
Before you start assembly, check the board for etching faults. Look for any shorts between tracks, or open circuits due to over etching. Take this opportunity to sand the edges of the board if needed, removing any splinters or rough edges.
Short spacers (or a couple of nuts) are needed to space the module boards off the rails so that there is space for the power wire, and so the PCB tracks on the modules are not shorted. I found 15mm M3 bolts to be adequate with the spacers I was using. The exact bolt length will depend on your choice of spacer.
The corner mounting bolts and spacers need to be long enough to clear your panel mounted components.
Wiring modules to the integral power bus. Each module on the panel is connected like this. The other ends of these wires to the rear of a module's onboard power connector. Power can now be fed to the whole panel through that board's power connector. Power connectors could be omitted from all but one PCB on the panel, although if installed, they are convenient for initial testing of the boards off-panel!
This is a guide only. Parts needed will vary with individual constructor's needs. Parts within the boxed area can be omitted if the switched outputs are not required.
|CGS91 V1.0 PCB||2|
- PCB Mounting Rail for Serge style panels. (archived) by Ken Stone, 2013, with permission of the author
- CGS91 BOM at BOMpiler
- CGS Synth discussion group, for discussion of locating parts, modifications and corrections etc.
- CGS91 PCB Mounting Rail, revision 1, Elby Designs