View source for CGS bus expansion port

The purpose of '''CGS99''' the '''CGS bus expansion port''' PCB is to allow easy connection for bus modules such as the CGS93 [[CGS trunk lines/multiples|Trunk Lines/Multiples]] and CGS98 [[CGS bus driver|Bus Driver]] to be distributed across several cases. It can also be used to connect a slave CGS73 [[CGS Eurorack power distribution board|Eurorack power distribution board]] to a power supply in a different cabinet, assuming the power supply is of sufficient capacity.

== How it works ==
[[File:cgs_photo_cgs99_port.jpg|thumb|center|600px|Front and rear of the PCB. The single connector is for connection to the rear of the CGS93 or CGS98 modules. The text on the overlay can be blacked out with a marker to show the purpose of the bus.]]
[[File:cgs_photo_cgs99_port2.jpg|thumb|center|600px|This is the back of the case, with two ports, one used for the CGS98 (Bus) and one used for the CGS93 (Mult). The different colors were for my convenience, as I had both to hand.]]
[[File:cgs_photo_cgs99_port3.jpg|thumb|center|600px|The rear of the CGS99, viewed from inside the case.]]
[[File:cgs_photo_cgs99_port4.jpg|thumb|center|600px|The rear of two cases, with the CGS99 linked by standard 16 way IDC connectors. The unused connectors would be used to link these cases to more cases.]]

== Construction ==
Before you start assembly, check the board for etching faults. Look for any shorts between tracks, or open circuits due to over etching. Take this opportunity to sand the edges of the board if needed, removing any splinters or rough edges.

First, solder the single connector onto the rear of the PCB, taking note of which way around the socket faces. There is a triangle molded onto these headers to indicate pin 1. The key is also marked on the PCB. Once this connector is soldered in, you can flip the PCB and solder on the other two connectors.

Note that three connectors ''cannot'' be put on the same side of the PCB.

== Parts list ==
This is a guide only. Parts needed will vary with individual constructor's needs.

{| style="border:1px solid #BBB;"
| Part||align=right|Quantity
|-
| 16pin (2 x 8 pin) box headers||align=right|3
|-
| CGS99 V1.0 PCB||align=right|2
|}

=== Notes ===
* PCB 2" x 2" with 3mm mounting holes 0.15" in from the edges.

== CC-BY-NC ==
Readers are permitted to construct these circuits for their own personal use only. Ken Stone retains all rights to his work.

== See also ==
* [[CatGirl_Synth#The_CGS_modules|The CGS modules]]
* [[CGS parts FAQ]]

== References ==
* ''[https://web.archive.org/web/20180209234737f/http://www.CGS.synth.net:80/modules/CGS99_port.html Bus expansion port for cases]'' by Ken Stone, 2014, with permission of the author - archived

== External links ==


[[Category:CGS general and accessories]]