CGSMULT the CGS multiple circuit board provides an easy and error-free way of wiring up a banana jack multiple.
Before you start assembly, check the board for etching faults. Look for any shorts between tracks (hehe), or open circuits due to over etching. Take this opportunity to sand the edges of the board if needed, removing any splinters or rough edges. (With the boards supplied by me, the edges are already milled, and etching faults are very rare.)
To use the wire anchor holes: 1) Trim off the end of a suitable gauge of hookup wire 2) Pass it through the larger (pad-less) hole from below and pull a couple of inches through. 3) Strip the insulation from the end of the wire, twist and tin it. 4) Bend the wire over and pass the tinned part through the associated pad hole. 5) Flip the board and solder the tinned wire to the pad. 6) Pull the excess wire back through the first hole so only a short length remains between the hole and the second pad. Make sure this is the LAST step, or the insulation will peel back from the wire as it is soldered.
This is a guide only. Parts needed will vary with individual constructor's needs.
- CGS MULTIPLE PCB (0.7" x 0.9" with four 3mm mounting holes 0.15" in from the edges).
Readers are permitted to construct these circuits for their own personal use only. Ken Stone retains all rights to his work.
- Multiple Board for music synthesizers. by Ken Stone, 2007, with permission of the author - archived