m
Text replacement - " (archived) by Ken Stone, 2006, with permission of the author" to " by Ken Stone, 2006, with permission of the author - archived"
m (Rescuing 1 sources and tagging 0 as dead. #IABot (v2.0beta15)) |
m (Text replacement - " (archived) by Ken Stone, 2006, with permission of the author" to " by Ken Stone, 2006, with permission of the author - archived") |
||
| (5 intermediate revisions by 2 users not shown) | |||
Line 165:
* Resistors marked RLED determine the brightness of the LEDs. A 1k resistor can be used for low mcd LEDs. If you use a superbright LED, this value should be increased, to as much as 33k, dependent on the individual LED. Trial and error is the only way to correctly determine the value. This can be done with a LED, resistor and a power supply of approximately the same voltage as the positive rail of your synth. (i.e. +12V or +15V)
* 33k resistors marked # on the schematic could be replaced with 100k resistors to bring the input impedances up to more modern standards.
== CC-BY-NC ==
Readers are permitted to construct these circuits for their own personal use only. Ken Stone retains all rights to his work. Serge Tcherepnin retains all rights to his work.
== See also ==
Line 171 ⟶ 174:
== References ==
* ''[https://web.archive.org/web/
== External links ==
=== Suppliers ===
* [https://web.archive.org/web/20181005193349/http://www.elby-designs.com/webtek/cgs/serge/cgs76/cgs76_env.html CGS76 1973 Envelope Generator], revision 1.2, Elby Designs
* [
[[Category:CGS
| |||