CGS Serge 1973 voltage controlled filter (view source)
Revision as of 17:10, 17 April 2019
, 5 years ago→Construction
(Created page with "thumb|center|600px| '''CGS77''' the '''CGS Serge 1973 voltage controlled filter''' is a licensed adaptation of the original Serge VCF. A stat...") |
|||
Line 9:
== Construction ==
[[File:cgs_wire_cgs77_vcf.gif|thumb|center|534px|The
[[File:cgs_pcb_cgs77_vcf.gif|thumb|center|600px|The component overlay for the VCF.]]
[[File:cgs_photo_cgs77v12_vcf.jpg|thumb|center|800px|Version 1.2 of the PCB. The board is double sided, but the circuit remains unchanged. Some labels have been adjusted. Of note: The frequency pot CW and CCW connections are shown as per the original VCF, i.e. backwards to standard convention. I would suggest you swap these wires!]]
[[File:cgs_photo_cgs77_vcf3.jpg|thumb|right|124px|]] Before you start assembly, check the board for etching faults. Look for any shorts between tracks, or open circuits due to over etching. Take this opportunity to sand the edges of the board if needed, removing any splinters or rough edges. (With the boards supplied by me, the edges are already milled, and etching faults are very rare.)
| |||
