2,282
edits
(Created page with "thumb|center|600px| '''CGS34''' the '''CGS analog shift register''' module (v1.2) is an analog control voltage shift register, three st...") |
m (Text replacement - " - archived" to " - archived") Tag: Manual revert |
||
(7 intermediate revisions by the same user not shown) | |||
Line 105:
! colspan="2" align=center|Misc
|-
| Ferrite
|-
| 0.156 4 pin connector||align=right|1
Line 115:
* A 10 to 22 ohm resistor can be used instead of the ferrite bead. If you don't care about power-rail noise, just use a link instead.
* PCB is 6" x 2" with 3mm mounting holes 0.15" in from the edges.
== CC-BY-NC ==
Readers are permitted to construct these circuits for their own personal use only. Ken Stone retains all rights to his work.
== See also ==
Line 124 ⟶ 127:
== References ==
* ''[https://web.archive.org/web/
== External links ==
=== Suppliers ===
* [http://www.elby-designs.com/webtek/CGS/CGS34/CGS34-asr.html CGS34 Analogue Shift Register], revision 2, Elby Designs
[[Category:CGS
|