no edit summary
No edit summary |
|||
Line 21:
* If you have a power bus that uses the MOTM standard for +/-15/+5, you can install a six pin 0.156 header, three Ferrite beads and three 10uF decoupling capacitors.
* If you only have +/-12 volt or +/-15 volt power available, install a four pin 0.156 header, two Ferrite beads, two 10uF decoupling capacitors, two 100n capacitors and a 78M05 (or similar) regulator. Refer to the photographs for component positioning.
== Notes ==▼
* 330R refers to 330 ohms. 100n = 0.1 uF, etc.▼
* The module will work on +/-12 volts or +/-15 volts.▼
* PCB dimensions are 6" x 2" with 3mm mounting holes 0.15" in from the edges.▼
== Parts list ==
Line 32 ⟶ 27:
{|style="border:1px solid #BBB; display:inline-table; margin-right:25px;"
| colspan="2"|Full module using 4 pin power
|-
| Part||align=right|Quantity
Line 60 ⟶ 53:
{|style="border:1px solid #BBB; display:inline-table;"
| colspan="2"|PCB used with 6 pin power
|-
| Part||align=right|Quantity
Line 81 ⟶ 72:
| CGS124 VER1.0 PCB||align=right|1
|}
▲=== Notes ===
▲* 330R refers to 330 ohms. 100n = 0.1 uF, etc.
▲* The module will work on +/-12 volts or +/-15 volts.
▲* PCB dimensions are 6" x 2" with 3mm mounting holes 0.15" in from the edges.
== See also ==
| |||