2,276
edits
(Created page with "thumb|center|600px| The idea for '''CGS13''' the '''CGS gated comparator''' project came when I was listening to some music in which part...") |
No edit summary |
||
Line 37:
When you are happy with the printed circuit board, construction can proceed as normal, starting with the resistors first, followed by the IC sockets if used, then moving onto the taller components.
Take particular care with the orientation of the polarized components, the electrolytics, LEDs, diodes, transistors and ICs.
When inserting the ICs in their sockets, take care not to accidentally bend any of the pins under the chip. Also, make sure the notch on the chip is aligned with the notch marked on the PCB overlay.
|