CGS master divider (previous version): Difference between revisions

← Older edit

CGS master divider (previous version) (view source)

Revision as of 14:50, 19 July 2022

159 bytes added , 1 year ago

m

Text replacement - " - archived" to " - archived"

VisualWikitext

Rob Kam

Bureaucrats, Administrators

2,154

edits

Revision as of 17:44, 12 December 2018 (view source) Rob Kam (talk \| contribs) (Created page with "<!-- file missing [[<!-- center\|100px --> '''CGS22''' the '''CGS master divider''' module is series of dividers and "phase shifters" for convertin...")		Latest revision as of 14:50, 19 July 2022 (view source) Rob Kam (talk \| contribs) m (Text replacement - " - archived" to " - archived") Tag: Manual revert
(9 intermediate revisions by the same user not shown)
Line 39: If you decide not to use the LEDs, a link should be installed in place of each LED. The 2k2 pull-down resistors should also be changed to 10k. Note, on the prototype boards, the 2k2 resistors are marked as 1k. The inputs to the networks which generate the 90° and 270° outputs are ~~labelled~~labeled S1 and S2 on the PCB. For each network a two pole, six position rotary switch connects each input to two successive outputs of the divider available via the pads ~~labelled~~labeled Q1 to Q6. As it does not matter which input of each network is used, it is possible to run a single wire from each "Q" output to the rotary switch, where it is connected to two adjacent pins, the exceptions being for Q1 and Q6 which are connected to a single pin each. Q0 is not used. '''~~Table~~Tables showing how to wire up the two rotary switches:''' {\|style="border:1px solid #BBB; display:inline-table; margin-right:25px;" \| PCB\|\|Switch 1 Line 143: ! colspan="2" align=center\|Misc \|- \| Ferrite ~~Bead~~bead (or 10R resistor)\|\|align=right\|1 \|- \| 0.156 4 pin connector\|\|align=right\|1 Line 152: === Notes === * A 10 ohm resistor can be used instead of the ferrite bead. If you don't care about power-rail noise, just use a link instead. == CC-BY-NC == Readers are permitted to construct these circuits for their own personal use only. Ken Stone retains all rights to his work. == See also == * [[CGS master divider]] for the ~~current~~latest version * [[CatGirl_Synth#The_CGS_modules\|The CGS modules]] == References == * [https://web.archive.org/web/~~20110821074829fw_~~20110821074829f/http://www.cgs.synth.net:80/modules/cgs22_master_divider.html Master Divider for music synthesizers.] ~~(archived)~~ by Ken Stone, 2001, with permission of the author - archived == External links == * [http://groups.yahoo.com/group/cgs_synth CGS Synth discussion group], for discussion of locating parts, modifications and corrections etc. [[Category:CGS ~~modular~~clock/gate/trigger processors]]