Synth DIY Wiki

CGS master divider (previous version): Difference between revisions

Page Talk

CGS master divider (previous version) (view source)

Revision as of 17:47, 12 December 2018

2 bytes removed ,  5 years ago
no edit summary
VisualWikitext
(Created page with "<!-- file missing [[<!-- center|100px --> '''CGS22''' the '''CGS master divider''' module is series of dividers and "phase shifters" for convertin...")
 
No edit summary
Line 39:
If you decide not to use the LEDs, a link should be installed in place of each LED. The 2k2 pull-down resistors should also be changed to 10k. Note, on the prototype boards, the 2k2 resistors are marked as 1k.
 
The inputs to the networks which generate the 90° and 270° outputs are labelledlabeled S1 and S2 on the PCB. For each network a two pole, six position rotary switch connects each input to two successive outputs of the divider available via the pads labelledlabeled Q1 to Q6. As it does not matter which input of each network is used, it is possible to run a single wire from each "Q" output to the rotary switch, where it is connected to two adjacent pins, the exceptions being for Q1 and Q6 which are connected to a single pin each. Q0 is not used.
 
'''Table showing how to wire up the two rotary switches:'''
Retrieved from "https://sdiy.info/wiki/Special:MobileDiff/15870"