CGS power supply delay: Difference between revisions

== Construction ==

[[File:cgs_pcb_cgs63_psd.gif|thumb|center|600px|The component overlay for the Power Supply Delay. The darker section is needed only if your system uses 5 volts as well as +/- 15 volts.]]

Before you start assembly, check the board for etching faults. Look for any shorts between tracks, or open circuits due to over etching. Take this opportunity to sand the edges of the board if needed, removing any splinters or rough edges. (With the boards supplied by me, the edges are already milled, and etching faults are very rare.)