CGS reverb: Difference between revisions

← Older edit

CGS reverb (view source)

Revision as of 17:31, 15 February 2023

415 bytes added , 1 year ago

Rescuing 1 sources and tagging 0 as dead.) #IABot (v2.0.9.3

VisualWikitext

InternetArchiveBot

Automoderated users, Bots

111

edits

Revision as of 23:48, 15 November 2018 (view source) Rob Kam (talk \| contribs) No edit summary ← Older edit		Latest revision as of 17:31, 15 February 2023 (view source) InternetArchiveBot (talk \| contribs) (Rescuing 1 sources and tagging 0 as dead.) #IABot (v2.0.9.3)
(9 intermediate revisions by 2 users not shown)
Line 81: \|} == ~~To set up~~Setup == <!-- file missing [[File:cgs_wire_cgs95v10_rev.jpg\|thumb\|center\|680px\|Example wiring for the Reverb.]] --> If you have access to an oscilloscope, you can monitor the input and of one of the "raw" reverb outputs, and adjust the GAIN trimmer so they match. Note that the reverb output will probably have greater excursions than the input signal, especially if you are just using a basic wave shape from a VCO. As such you are setting the level of the "bulk" of the waveform. The alternative method is to adjust the GAIN trimmer until they sound about the same. Line 143: ! colspan="2" align=center\|Misc \|- \| Ferrite ~~Bead~~bead\|\|3 (2) \|- \| 0.156 4 pin connector\|\|A=0 B=1 Line 158: * 330R refers to 330 ohms. 100n = 0.1μF. * PCB is 6" x 1.5" with 3mm mounting holes 0.15" in from the edges. Extra holes are provided to match the CGS91 mounting rails, with left or right offsets, or centered. == CC-BY-NC == Readers are permitted to construct these circuits for their own personal use only. Ken Stone retains all rights to his work. == See also == Line 164 ⟶ 167: == References == * ''[https://web.archive.org/web/~~20180209234737fw_~~20180209234737f/http://www.cgs.synth.net:80/modules/cgs95_rev.html Reverb for music synthesizers.]'' ~~(archived)~~ by Ken Stone, 2013, with permission of the author - archived == External links == Line 171 ⟶ 174: * [http://www.accutronicsreverb.com/ www.accutronicsreverb.com] has further details on the Belton BTDR-2H, (Flash heavy site). * [http://groups.yahoo.com/group/cgs_synth CGS Synth discussion group], for discussion of locating parts, modifications and corrections etc. * [http://bompiler.com/pcb/cgs95 CGS95 BOM] at BOMpiler === Suppliers === * [https://web.archive.org/web/20181122000455/http://www.elby-designs.com/webtek/cgs/cgs95/cgs95_rev.html CGS95 Digital Reverb], revision 1, Elby Designs === Belton BTDR-2H suppliers === * [https://web.archive.org/web/20181112142238/http://www.smallbear-electronics.mybigcommerce.com/belton-btdr-2h-reverb-modules/ Small Bear Electronics LLC] * [https://www.thonk.co.uk/shop/belton-reverb-brick/ Thonk Ltd.] [[Category:CGS ~~modular~~signal processors]]