m
Text replacement - "== To set up ==" to "== Setup =="
No edit summary |
m (Text replacement - "== To set up ==" to "== Setup ==") |
||
Line 81:
|}
==
<!-- file missing [[File:cgs_wire_cgs95v10_rev.jpg|thumb|center|680px|Example wiring for the Reverb.]] -->
If you have access to an oscilloscope, you can monitor the input and of one of the "raw" reverb outputs, and adjust the GAIN trimmer so they match. Note that the reverb output will probably have greater excursions than the input signal, especially if you are just using a basic wave shape from a VCO. As such you are setting the level of the "bulk" of the waveform. The alternative method is to adjust the GAIN trimmer until they sound about the same.
| |||