This is just a quick, photographic guide for the one or two people out there that actually have the CGS122 switched matrix or CGS123 switched matrix Eurorack boards.

A little on how it works

 
Partial schematic. The rest is simply more of the same.

Construction

 
CGS123 Circuitry PCB.
 
Rear of CGS123 Circuitry PCB.
 
Switch PCB. Note that only half of the resistor positions are used. 1/8 W resistors are required. All resistors on this board are 100k 1%.
 
Switch PCB. Note that only half of the resistor positions are used. 1/8 W resistors are required. The second resistor position is for a second matrix on the same board, allowing for stereo switching. The CGS123 interface board is only mono.
 
Rear of switch PCB.

CC-BY-NC

Readers are permitted to construct these circuits for their own personal use only. Ken Stone retains all rights to his work.

See also

References

External links