no edit summary
No edit summary |
|||
(15 intermediate revisions by 4 users not shown) | |||
Line 1:
[[File:C4128_large_jumper_wires_20cm_m-f_pack_10.jpg|thumb|right|200px|Male to female jumper wire strip]]
[[File:Jumper Wires with Crocodile Clips.jpg|thumb|right|200px|Jumper wires with crocodile clips, aka test leads.]]
[[File:Arduino_Breadboard_ATmega328P_USB2Serial.jpg|thumb|right|200px|A ribbon cable connects the pin sockets of an Arduino USB 2 Serial micro to a breadboard and wire jumpers make interconnections on the breadboard.]]
A '''jumper wire''' also known as '''jumper link''', '''jumper''', '''jump wire''' or '''DuPont cable''' is a connecting wire, bare at the ends or terminated with some type of connector. These are used in prototyping, installed as part of the circuit assembly, added after assembly to modify a circuit or added to correct a defect.<ref name="ctc">[http://www.circuitrework.com/guides/6-1.html 6.1 Jumper Wires], Circuit Technology Center</ref>
== Use in prototyping ==
Jumper wires of insulated 26[[American wire gauge|AWG]] wire terminated with [[crimping|crimped]] pins or sockets in plastic housing are used to make connections between [[pin headers]] or sockets. With 2.5 mm (0.1 inch) housing they're suitable for interfacing single board computers like the [[Arduino]] and [[Raspberry Pi]]. These will also fit without damage to interconnect the components on solderless [[breadboard]] although here 22 AWG solid-core hookup wire with bare ends can be used instead.<ref>[https://www.rapidonline.com/jumper-wires-for-breadboard-arduino-raspberry-pi-olimex-etc-544268 Jumper Wires for Breadboard, Arduino, Raspberry Pi, Olimex, etc.], Rapid Electronics</ref>
== Use in repair/modification ==
''See [[Repairs]] and [[PCB repair]]''
== DuPont crimp connectors ==
A DuPont crimp consists of two parts,
Using the proper crimping tool makes a good crimp joint easy. A properly crimped joint does not need soldering and is more than strong enough.<ref>[http://renoirsrants.blogspot.co.uk/search/label/Crimping Crimping], by Dave Renoir, 20 October 2011</ref> Most crimp terminals are designed to be crimped, not soldered. Soldering a crimped terminal may weaken the mechanical connection, reduce electrical conductivity, and damage the terminal.
== See also ==
* [[Wire link]]
* [[Jumper]]
* [[Hookup wire]]
== References ==
Line 20 ⟶ 24:
== External links ==
* [https://forum.arduino.cc/index.php?topic=376971.0 FYI Making DuPont jumper wires.], Arduino Forum, Feb 2016
* [https://electronics.stackexchange.com/questions/179179/what-is-the-official-name-for-these-jumper-wires/179183#179183 What is the official name for these jumper wires?], StackExchange EE
=== Suppliers ===
* [http://www.mouser.co.uk/Tools-Supplies/Prototyping-Products/Jumper-Wires/_/N-bkrh0 Mouser]
* [https://www.digikey.com/products/en/prototyping-products/jumper-wire/640 Digi-Key]
* [https://www.rapidonline.com/jumper-wires-for-breadboard-arduino-raspberry-pi-olimex-etc-544268 Rapid]
[[Category:Connectors]]
|