2,221
edits
No edit summary |
m (Text replacement - " - archived" to " - archived") Tag: Manual revert |
||
(7 intermediate revisions by the same user not shown) | |||
Line 5:
== How to use this module ==
This module is designed to connected to either a 16 or 8 bit bus, and contains two latches that can be latches independently. For a backplane/bus common [[stripboard]] may be used, along with 0.1 pitch 90° headers. It can be used with the [[
While untested, the analog portion of the module should work on 12 volts. The digital portion requires 5 volts.
Line 60:
! colspan="2" align=center|Misc
|-
| Ferrite
|-
| CGS11 PCB||align=right|1
Line 69:
* Different latch chips with the same pin configuration can be used in the circuit. The obsolete 74LS273 can be used if '''A''' is linked to '''B''' instead of '''D'''. Check your data books.
* 10 to 22 ohm resistors can be used instead of the ferrite beads. If you don't care about power-rail noise, just use a link instead.
== CC-BY-NC ==
Readers are permitted to construct these circuits for their own personal use only. Ken Stone retains all rights to his work.
== See also ==
Line 75 ⟶ 78:
== References ==
* ''[https://web.archive.org/web/
== External links ==
* [http://groups.yahoo.com/group/cgs_synth CGS Synth discussion group], for discussion of locating parts, modifications and corrections etc.
[[Category:CGS
|