CGS Serge resonant equalizer: Difference between revisions
Jump to navigation
Jump to search
Content added Content deleted
| Line 15: | Line 15: | ||
== Construction == |
== Construction == |
||
[[File:cgs_pcb_cgs202v1.1_re.gif|thumb|center|900px|The component overlay for the VER1.0 PCB. Click through for an enlarged, printable version. Print at 300dpi.]] |
[[File:cgs_pcb_cgs202v1.1_re.gif|thumb|center|900px|The component overlay for the VER1.0 PCB. Click through for an enlarged, printable version. Print at 300dpi.]] |
||
[[File:cgs_panel_res_eq.gif||thumb|right| |
[[File:cgs_panel_res_eq.gif||thumb|right|120px|]] |
||
Before you start assembly, check the board for etching faults. Look for any shorts between tracks, or open circuits due to over etching. Take this opportunity to sand the edges of the board if needed, removing any splinters or rough edges. |
Before you start assembly, check the board for etching faults. Look for any shorts between tracks, or open circuits due to over etching. Take this opportunity to sand the edges of the board if needed, removing any splinters or rough edges. |
||