CGS breadboard: Difference between revisions
Jump to navigation
Jump to search
Content added Content deleted
No edit summary |
|||
Line 21: | Line 21: | ||
* If you have a power bus that uses the MOTM standard for +/-15/+5, you can install a six pin 0.156 header, three Ferrite beads and three 10uF decoupling capacitors. |
* If you have a power bus that uses the MOTM standard for +/-15/+5, you can install a six pin 0.156 header, three Ferrite beads and three 10uF decoupling capacitors. |
||
* If you only have +/-12 volt or +/-15 volt power available, install a four pin 0.156 header, two Ferrite beads, two 10uF decoupling capacitors, two 100n capacitors and a 78M05 (or similar) regulator. Refer to the photographs for component positioning. |
* If you only have +/-12 volt or +/-15 volt power available, install a four pin 0.156 header, two Ferrite beads, two 10uF decoupling capacitors, two 100n capacitors and a 78M05 (or similar) regulator. Refer to the photographs for component positioning. |
||
⚫ | |||
⚫ | |||
⚫ | |||
⚫ | |||
== Parts list == |
== Parts list == |
||
Line 32: | Line 27: | ||
{|style="border:1px solid #BBB; display:inline-table; margin-right:25px;" |
{|style="border:1px solid #BBB; display:inline-table; margin-right:25px;" |
||
| colspan="2"|Full module using 4 pin power |
| colspan="2"|Full module using 4 pin power |
||
|- |
|||
| <!-- --> |
|||
|- |
|- |
||
| Part||align=right|Quantity |
| Part||align=right|Quantity |
||
Line 60: | Line 53: | ||
{|style="border:1px solid #BBB; display:inline-table;" |
{|style="border:1px solid #BBB; display:inline-table;" |
||
| colspan="2"|PCB used with 6 pin power |
| colspan="2"|PCB used with 6 pin power |
||
|- |
|||
| <!-- --> |
|||
|- |
|- |
||
| Part||align=right|Quantity |
| Part||align=right|Quantity |
||
Line 81: | Line 72: | ||
| CGS124 VER1.0 PCB||align=right|1 |
| CGS124 VER1.0 PCB||align=right|1 |
||
|} |
|} |
||
⚫ | |||
⚫ | |||
⚫ | |||
⚫ | |||
== See also == |
== See also == |