CGS dev-mod generic prototyping block
CGS71 the CGS dev-mod generic prototyping block development module is merely a small prototyping area.
Construction
In this case I would recommend flipping the board left-to-right and putting your parts on the track side of the board. This makes for much quicker and more accurate prototyping as you do not have to continually flip the board during contraction. Flipping left-to-right keeps your power rails the right way up.
Around the edge of the board are rows of pads suitable for adding headers to allow dev-blocks to be linked together using the CGS72 joiner or plain old pin header jumpers. Apart from the power rails, these are not assigned, so as to allow maximum versatility. You will need to link these pads to the inputs and outputs of the circuit blocks as required.
The remainder of the assembly instructions are generic. What exactly you build on it is entirely up to you.
Before you start assembly, check the board for etching faults. Look for any shorts between tracks, or open circuits due to over etching. Take this opportunity to sand the edges of the board if needed, removing any splinters or rough edges. (With the boards supplied by me, the edges are already milled, and etching faults are very rare.)
When you are happy with the printed circuit board, construction can proceed as normal, starting with the resistors first, followed by the IC socket if used, then moving onto the taller components.
Take particular care with the orientation of the polarized components such as electrolytics, diodes, transistors and ICs.
Parts list
This is a guide only. Parts needed will vary with individual constructor's needs.
Part | Quantity |
Misc | |
---|---|
0.1 headers | as required |
CGS71 PCB | 1 |
Notes
- PCB 2" x 2" with four 3mm mounting holes 0.15" in from the edges.
CC-BY-NC
Readers are permitted to construct these circuits for their own personal use only. Ken Stone retains all rights to his work.
See also
References
- Dev-mod generic block for music synthesizers. by Ken Stone, 2007, with permission of the author - archived
External links
- CGS Synth discussion group, for discussion of locating parts, modifications and corrections etc.