CGS display adapter: Difference between revisions
Jump to navigation
Jump to search
Content added Content deleted
(Created page with "thumb|center|228px| '''CGS12''' the '''CGS display adapter''' board was developed to go with the CGS wavetable for VCOs|CGS wav...") |
No edit summary |
||
| Line 32: | Line 32: | ||
The sub-board that contains the two displays needs to be soldered at right angles to the main board. There are a series of large pads to assist with this. There are also a couple of small holes so a short length of tinned copper wire can be used to secure them together before you start soldering. |
The sub-board that contains the two displays needs to be soldered at right angles to the main board. There are a series of large pads to assist with this. There are also a couple of small holes so a short length of tinned copper wire can be used to secure them together before you start soldering. |
||
The edge main board buts up against the bottom of the display board. Solder two short lengths of tinned copper wire between the corner holes on the main and display boards. These will help you position the two boards so the connections between them can be |
The edge main board buts up against the bottom of the display board. Solder two short lengths of tinned copper wire between the corner holes on the main and display boards. These will help you position the two boards so the connections between them can be easily soldered. |
||
=== Notes === |
=== Notes === |
||
