CGS sequential switch: Difference between revisions
Jump to navigation
Jump to search
Content added Content deleted
m (→Notes) |
m (→Notes) |
||
Line 142: | Line 142: | ||
=== Notes === |
=== Notes === |
||
* A link be used instead of the ferrite beads if you don't care about power-rail noise. |
* A link be used instead of the ferrite beads if you don't care about power-rail noise. |
||
*Note that the second op amp of the TL072 (the Inverted Out) show wrong pin numbers. 5 and 6 should be swapped. The polarity is right though. |
*Note that in the schematic the second op amp of the TL072 (the Inverted Out) show wrong pin numbers. 5 and 6 should be swapped. The polarity is right though. |
||
== CC-BY-NC == |
== CC-BY-NC == |