Knobs: Difference between revisions
Jump to navigation
Jump to search
Content added Content deleted
m (→Buchla) |
mNo edit summary |
||
Line 1: | Line 1: | ||
'''Knobs''' fit on controls, e.g. [[push buttons]], [[potentiometers]] or sliders and [[rotary switches]]. |
|||
== Use with potentiometers == |
== Use with potentiometers == |
||
Splined push on knobs fit splined pot shafts. Pots with with round or D shafts require knobs with plain holes that if not push fit, have set screws to hold them in place. Most spline shaft pots have a slightly smaller diameter shaft than round or D shaft. Usually splines are 6mm while most round ones are 1/4" (6.35mm). So 1/4" setscrew knobs will end up slightly lopsided when tightened onto a 6mm spline shaft. Knobs fastened by a collet require a box spanner to fasten them.<ref>[https://www.muffwiggler.com/forum/viewtopic.php?t=54215&sid=0c1a5b9d1c9d353c1a8e025489dcf6ac knurled vs round shaft pots], Muff Wiggler forum, March 2012</ref><ref>Wikipedia: [https://en.wikipedia.org/wiki/Control_knob Control knob]</ref> |
[[File:Potentiometer knob with set screw.jpg|thumb|right|200px|Potentiometer knob with set screw.]][[File:10K Potentiometer 1480313 4 5 Enhancer.jpg|thumb|right|200px|Splined shaft on potentiometer.]]Splined push on knobs fit splined pot shafts. Pots with with round or D shafts require knobs with plain holes that if not push fit, have set screws to hold them in place. Most spline shaft pots have a slightly smaller diameter shaft than round or D shaft. Usually splines are 6mm while most round ones are 1/4" (6.35mm). So 1/4" setscrew knobs will end up slightly lopsided when tightened onto a 6mm spline shaft. Knobs fastened by a collet require a box spanner to fasten them.<ref>[https://www.muffwiggler.com/forum/viewtopic.php?t=54215&sid=0c1a5b9d1c9d353c1a8e025489dcf6ac knurled vs round shaft pots], Muff Wiggler forum, March 2012</ref><ref>Wikipedia: [https://en.wikipedia.org/wiki/Control_knob Control knob]</ref> |
||
== Knobs in common use == |
== Knobs in common use == |