CGS gate converter

Jump to navigation Jump to search

The purpose of CGS56 the CGS gate converter (design by Richard Brewster, PCB by Ken Stone), is to turn standard positive gate signals into negative to positive going gate signal. This is particularly handy when interfacing to other manufacturer's modules that require a zero crossing signal to operate. It can also be used to convert assorted LFO or VCO signals to square or rectangular waves, to extract some form of gate signal from an envelope and so on.

To use the module with +/-12 volts, replace the 3k3 resistors with 2k2 or 2k4 resistors.

A little on how it works

The schematic of the Gate Converter.

This circuit is a basic comparator with a little hysteresis. It is set to detect input voltages above or below the reference voltage of approximately 1.4 volts. The output of the comparator is then reduced by the resistive divider to approximately + or - 5 volts, depending on whether the input voltage is above or below the reference voltage.

There are 4 identical units on the PCB.

Construction

The component overlay of the first version of the board, including a wiring example.
The component overlay of the VER1.1 PCB. Wiring remains the same as the example shown above. Click through for an enlarged printable version.

Before you start assembly, check the board for etching faults. Look for any shorts between tracks, or open circuits due to over etching. Take this opportunity to sand the edges of the board if needed, removing any splinters or rough edges.

When you are happy with the printed circuit board, construction can proceed as normal, starting with the resistors first, followed by the IC socket if used, then moving onto the taller components.

Take particular care with the orientation of the polarized components such as electrolytics, diodes, transistors and ICs.

When inserting ICs into sockets, take care not to accidentally bend any of the pins under the chip. Also, make sure the notch on the chip is aligned with the notch marked on the PCB overlay.

This board can be integrated into a module as either an input processor or output processor, or wired up as a regular utility module.

Parts list

This is a guide only. Parts needed will vary with individual constructor's needs.

Part Quantity
Capacitors
100n 2
Resistors
1k8 4
2k2 4
3k3 4
10k 1
100k 1
2M2 4
Semi's
TL074 1
Misc
CGS56 PCB 1

Notes

  • PCB is 1.15" x 2" with two 3mm mounting holes 0.15" in from the bottom and edges. It is designed to sit above one end of a regular 2" width CGS PCB.

CC-BY-NC

Readers are permitted to construct these circuits for their own personal use only. Ken Stone retains all rights to his work.

See also

References

External links

Suppliers