CGS switched matrix

This is just a quick, photographic guide for the one or two people out there that actually have the CGS122 switched matrix or CGS123 switched matrix Eurorack boards.

A little on how it works

Partial schematic. The rest is simply more of the same.

Construction

CGS123 Circuitry PCB.

Rear of CGS123 Circuitry PCB.

Switch PCB. Note that only half of the resistor positions are used. 1/8 W resistors are required. All resistors on this board are 100k 1%.

Switch PCB. Note that only half of the resistor positions are used. 1/8 W resistors are required. The second resistor position is for a second matrix on the same board, allowing for stereo switching. The CGS123 interface board is only mono.

Rear of switch PCB.

See also

• The CGS modules
• CGS parts FAQ

References

• Matrix switch array for music synthesizers. (archived) by Ken Stone, 2013, with permission of the author

External links

• CGS Synth discussion group, for discussion of locating parts, modifications and corrections etc.