SMT hand soldering
Jump to navigation
Jump to search
SMT hand soldering ...
Use a lot of liquid flux and use visual magnification aids. Put some solder on a corner pad, heat the pad and place a corner lead. Tack down the opposite corner. Apply a little solder to the iron and drag it over the pins. To remove solder bridges, clean the iron of any solder and apply again across the pins or, if possible, drawing it away from the pins.
To clean flux residue, use 99% isopropyl alcohol, which is close to the anhydrous (100%) isopropyl alcohol commonly used in industry to clean PCBs.[1]
See also
References
- ^ EEVblog Electronics Community Forum, Cleaning flux residue, 17 February 2011
External links
- Seb's brief guide to surface mount soldering by hand
This article is a stub. You can help the Synth DIY Wiki by expanding it. |